The Shiny is an 86 W dual LED curing lamp with 39 diodes, emitting at both 365 nm and 405 nm. Two wavelength bands cover formulations that a single-band lamp cannot reach, which is the usual reason a gel stays tacky or lifts early.
The light is white rather than the violet cast of older UV tubes, so it is easier on the eyes across a full day. A motion sensor starts the cure when a hand goes in, saving you from reaching for a button with product on the brush.
Low Heat Mode
The 99-second setting raises power in stages every 30 seconds instead of going to full output immediately. That takes the burning sensation out of curing thick builder gel, and it is the setting to use on clients with thin nail plates.
Technical data
- Power: 86 W, 39 diodes
- Wavelengths: 365 nm and 405 nm (dual LED)
- Timer: 10 s, 30 s, 60 s, 99 s (Low Heat Mode)
- Motion sensor: cures up to 99 s continuously
- Colour: pearl violet
- Display: large electronic timer readout
Good to know
The 10-second step is the one you will use most outside full cures: enough to set a bead before shaping, without committing the whole nail.
Power supply
This device ships with an EU plug. A UK adapter is included in the box, so it works on a UK socket straight away.
