The Glow X is a 54 W dual LED lamp with 24 diodes emitting at both 365 nm and 405 nm. Two wavelength bands matter because some gel formulations cure poorly under a single band, which is what leaves a gel tacky or lifting a week later.
The light is white rather than the violet cast of older UV tubes, so it is easier on the eyes across a full day. A motion sensor starts the cure when a hand goes in, which saves reaching for a button with product on the brush.
Low Heat Mode
The 99-second setting raises power in stages every 30 seconds instead of going to full output immediately. That is what takes the burning sensation out of curing thick builder gel, and it is the setting to use on clients with thin nail plates.
Technical data
- Power: 54 W, 24 diodes
- Wavelengths: 365 nm and 405 nm (dual LED)
- Timer: 10 s, 30 s, 60 s, 99 s (Low Heat Mode)
- Motion sensor: cures up to 120 s continuously
- LED life: 50,000 hours
- Display: large electronic timer readout
Good to know
The four timer steps make this a practical lamp for mixed work: 10 seconds to flash-cure and set a bead before shaping, 60 or 99 for a full cure.
Power supply
This device ships with an EU plug. A UK adapter is included in the box, so it works on a UK socket straight away.
